Proper installation and regular maintenance are essential to ensure your Enze faucet delivers years of reliable performance. This guide covers the key steps and best practices to keep your fixtures in top condition.
Installation Steps
- Prepare the workspace: Turn off the water supply at the main valve and drain the lines. Clear the area under the sink to access the plumbing.
- Remove the old faucet: Disconnect the supply lines and lift the old faucet from the sink. Clean the mounting surface thoroughly.
- Install the new faucet: Place the gasket or plumber’s putty on the base of the new faucet. Insert it through the sink holes and secure it with the mounting nuts from below.
- Connect the supply lines: Attach the hot and cold water supply lines to the corresponding valves on the faucet. Use a wrench to tighten the connections, but avoid over-tightening to prevent damage.
- Test for leaks: Turn the water supply back on and run the faucet. Check for leaks at the connections and the base of the faucet. If any leaks are found, tighten the connections or replace the washers.
Maintenance Tips
- Clean regularly: Wipe the faucet with a soft cloth and mild soap to remove water spots and dirt. Avoid abrasive cleaners or scouring pads, as they can scratch the finish.
- Clean the aerator: Unscrew the aerator from the spout and rinse it under running water to remove mineral deposits. Soak it in vinegar for 30 minutes if it’s clogged.
- Check for leaks: Inspect the supply lines and connections periodically for signs of leaks. If you notice a leak, turn off the water supply and contact a professional plumber.
- Avoid harsh chemicals: Chlorine-based cleaners, bleach, and ammonia can damage the finish of your faucet. Use only cleaners that are recommended for your specific finish.
- Insulate in cold climates: If your faucet is installed in an area that is exposed to freezing temperatures, insulate the pipes to prevent freezing and cracking.
By following these simple steps, you can extend the life of your Enze faucet and ensure it continues to perform at its best. If you have any questions or need assistance with installation or maintenance, please contact our customer support team.